Hello I have a
problem, I installed JTalert 2.50.5 with WSJTX 2.4.0 and desktop
NET 3.0.9 on Windows10 64 bits. Everything is 64 bits. Problem
apears after JTalert start decoding callsigns in the callsign
window and then a popup box appears saying error lIne 10388
variable used without being declared.
I re-installed JTalert but problem remain the same.
Any Advice ?
73 André VE2WNF
This type of random error is normally
infrequent and typically occurs only once or twice for the small
number of users who experience it. There is no known cause or fix.
If you are getting the error every time JTAlert starts decoding
suggests a problem with the log file that JTAlert is reading to
determine the B4 status. Are you using HRDLogbook? If so, that may
be the problem. In recent months a small number of HRD users have
experienced problems that were resolved by creating a new logfile
within HRDLogbook and importing the QSOs from the old log into the
new log. You will then need to set the new logfile in the JTAlert
Settings. See if that works for you.
If you're not using a HRD log, perhaps it is the JTAlert config
file that is a problem. You can try deleting the file and allowing
JTAlert to automatically create a new file. You will need to
re-enter all your old settings as they will be lost when you
delete the config file. For your Callsign the config file can be
found at %localappdata%\HamApps\VE2WNF\config\JTAlertX\config.sqlite
Stop JTAlert, delete that file or move it to a safe location,
start JTAlert.
Hello I have a problem, I installed JTalert 2.50.5 with WSJTX 2.4.0 and desktop NET 3.0.9 on Windows10 64 bits. Everything is 64 bits. Problem apears after JTalert start decoding callsigns in the callsign window and then a popup box appears saying error lIne 10388 variable used without being declared. I re-installed JTalert but problem remain the same.
