locked Re: Dimension 4 clock software issue
|
John P.
Just adding my 2 cents here............ I found on my Win 7 systems that I needed to run D4 as administrator. Otherwise the system sometimes would not accept the time correction from D4 John - WA2HIP
On Thursday, August 20, 2015 9:26 PM, "'Patrick J. Fagan' pfagan@... [HamApps]" wrote: Mike:
I am running Windows 10 Pro with Dimension 4. D4 does not disable the
connection to Windows Time Server, at least not on my machines (I have 2
computers running D4). After reading the thread this morning I checked and
Windows Time Sync was still running. After I turned it off Windows 10 Pro
stated that it was not enabled.
I have not checked this out on Windows 8.1, 8.0 or 7 so I can’t speak about
that. Your findings may be different. Dimension 4 is working fine
here. I have my time sync set for every 5 minutes. That may be a
little aggressive but so far there has not been an issue. Since using D4 I have
stopped getting notices to “set my clock” when running JT65 or JT9.
Pat – WA5DVV
=====
From: mailto:HamApps@...
Sent: Thursday, August 20, 2015 6:13 AM
To: HamApps@...
Subject: Re: [HamApps] Dimension 4 clock software issue
I do believe Dimension 4 disables the windows time service itself.
So you should see that it's already disabled.
73
Mike W9MDB
|
|
|