So I have WSJT-X prompting me when it is ready to log a
contact. Until now JTAlerts confirms that it is logging to ACLog
and all was well. Now I am getting this message from JTAlert
that says.
Failure: QSO not logged
Error Message: ACLOG File unable to confirm QSO logged
Not sure what has changed but any ideas what I should look for?
I’m not sure what to look for. Any help appreciated.
Thank you,
Paul
N5DUP
This has been discussed many times.
This error message indicates that JTAlert was unable to confirm
that the QSO was successfully logged. It does this by performing a
direct read of your Loggers log file/database. JTAlert doesn't
rely on the logging status produced by some loggers which have
shown to incorrectly indicate successful logging even when failing
to log the QSO. Also some loggers don't provide any feedback at
all when logging via their API, so JTAlert always tries to confirm
success/failure via a direct log/database read.
If the QSOs are indeed
getting logged you will need to increase the "Check QSO Log
Record" time. See the Logging section of the JTAlert Settings
window.
Very likely the post logging activities being performed by your
logger are being impacted by Internet access speeds resulting in
later than normal logging. Typical examples are post logging XML
lookups or posting the QSO to online logs.
